All you need is white
fabric and red fabric to make this pretty cupid's silhouette
Valentine's day decoration.
directions on the heatbond or "wonder-under", or follow our basic
Press a piece of heatbond (the shinny side
down) onto the wrong side of a piece of red fabric. Do not keep the iron
on the heatbond for more than a few seconds, just long enough to make the
Pin and cut out
the letters and cupid. This is a little time consuming and you need a
Peel off the back
of the heatbond from cupid and the letters.
Place cupid and
the letters onto the pretty side of one of the pillow pieces and iron on.
Once again, do not keep the iron on the fabric for a long time, it could
melt the heatbond. Also, do not move the iron back and forth. Place the
iron down and hold for a few seconds, then pick up the iron and move it to
another section, do not slide the iron.
Pin the pillow
pieces right sides (or pretty sides) together. Leave about a 3.5" opening
on the side.
If you are redistributing content or photos from our site for
another website or blog you must provide prominent link backs to the
source pages used on LovetoSew.com. If you are using any content or photos from our site to copy, share,
or use for any other reason, you need prior permission from the
author. Most requests are granted. Thank you.